Refurbishing Process


  1. Disassemble hospital bed: Remove headboard/footboard, rails, sleep surfaces, printed circuit boards, caster and wheels and all labels
  2. Clean/Prep bed & eradicate hidden dust particles (air blow)
  3. Sand & Repaint completely: Hospital Bed frame, rails, sleep surfaces & motor covers
  4. Spring Sleep Surfaces: Sanitize, sand & replace all defective/rusted helicals
  5. Orthopedic Sleep Surfaces: Sanitize, sand & completely repaint
  6. Install new Tente® Caster Assemblies: Stems, Forks & Wheels
  7. Install new Plastics on siderails: Top canes, End canes & Switch housings
  8. Install new Switches in siderails: Head, Hi-Lo & Knee
  9. Test hospital bed Communications: Entertainment, Nurse call & Bed exit
  10. Full-function test using OEM Side Com test equipment
  11. PCB Controls: Clean, test, repair & final test under full motor load
  12. Motors: Test, grease drive assembly & repair/replace as necessary
  13. Replace all Motor Couplings & Capacitors
  14. Dielectric Test (high voltage insulation) & Leakage Test (leakage to ground)
  15. Electrical safety test bed to the original (OEM) specifications
  16. Affix all new labels: Safety warning, Instruction & Product marketing
  17. Retention of permanent Hill-Rom® serial ID
  18. Install NEW Headboard & Footboard: Choice of color laminate


* The level of refurbishing can be tailored to meet your needs